2018-08-14, 10:55 AM
(This post was last modified: 2018-08-14, 11:01 AM by MilesAhead.)
I'm trying to configure a DTech serial to USB converter to pick up the NMEA 0183 signals from a Raymarine SmartPilot. See page 4 in the commissioning manual. I have an S1.
My issue is that I do not see the "USB Manager", "NMEA 0183", or "NMEA 2K" tabs as described in the OpenPlotter documentation. All I see is a "Serial" tab, followed by the "Signal K" tab.
Is there a configuration setting? Have I installed the incorrect version of OP?
BTW, I have a RPi 3 with the latest raspbian and I installed the latest NOOB version of OP/OpenCPN, then I updated OP & OpenCPN using OP.
My issue is that I do not see the "USB Manager", "NMEA 0183", or "NMEA 2K" tabs as described in the OpenPlotter documentation. All I see is a "Serial" tab, followed by the "Signal K" tab.
Is there a configuration setting? Have I installed the incorrect version of OP?
(2018-08-14, 10:55 AM)MilesAhead Wrote: I'm trying to configure a DTech serial to USB converter to pick up the NMEA 0183 signals from a Raymarine SmartPilot. See page 4 in the commissioning manual. I have an S1.
My issue is that I do not see the "USB Manager", "NMEA 0183", or "NMEA 2K" tabs as described in the OpenPlotter documentation. All I see is a "Serial" tab, followed by the "Signal K" tab.
Is there a configuration setting? Have I installed the incorrect version of OP?
BTW, I have a RPi 3 with the latest raspbian and I installed the latest NOOB version of OP/OpenCPN, then I updated OP & OpenCPN using OP.
regards
Trevor
skype: trevor_miles
Trevor
skype: trevor_miles