2018-06-13, 10:43 PM
I use the Prolific PL2303 chipset USB serial adapters - I've always heard FTDI was better, but these are the cheapest, and therefore what I use.
Instead of USB/Serial adapter maybe you can use the new button to enable the UART on Openplotter 1.0.0 and wire to the TX and RX pins (?) on the PI. This was for use by pypilot but perhaps it can be assigned to kplex. Caution - don't assume I know what I'm talking about.
Instead of USB/Serial adapter maybe you can use the new button to enable the UART on Openplotter 1.0.0 and wire to the TX and RX pins (?) on the PI. This was for use by pypilot but perhaps it can be assigned to kplex. Caution - don't assume I know what I'm talking about.