This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Connecting NMEA Wind data from NASA Clipper

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Connecting NMEA Wind data from NASA Clipper
PaddyB Offline
Moderator
*****
Posts: 1,169
Threads: 98
Joined: Mar 2016
Reputation: 69
#40
2018-06-17, 06:48 PM (This post was last modified: 2018-06-17, 06:49 PM by PaddyB.)
(2018-06-17, 06:01 PM)Smartell Wrote: Ok,

Now i have compared  putty sessions in Raspbian+OpenPlotter with a clean new Raspbian only (noob)  installation. Same hardware, same USB/R232 adapter, only swapping the SD card, leaving all other things in place. 

In the openplotter setup could something else be connecting to the serial input as well as putty? You could try  typing "startup stop" in a terminal to stop openplotter running then try putty again.
Find
Reply


Messages In This Thread
RE: Connecting NMEA Wind data from NASA Clipper - by PaddyB - 2018-06-17, 06:48 PM

Forum Jump:


Users browsing this thread: 5 Guest(s)