2018-05-23, 06:19 AM
(This post was last modified: 2018-05-23, 06:21 AM by Alpenskipper.)
Hi,
I installed the USB-N2K converter for the seatalk ng network.
The problem is, that I receive a lot of double sigK keys.
There are e.g. two SOG keys in sigK diagnostic, one is valid, the other one produces faulty values, that disturb the SOG reading.
Both values seem to come from the USB adapter. When I have a look on the PGNs directly, there are no double values.
I got the hint, here in the forum, to filter the faulty keys in kplex. I tried to set up a filter in manual section of the kplex.conf, but it did not work.
Could someone please point me into the right direction and give me a example how the filter is used?
Martin
I installed the USB-N2K converter for the seatalk ng network.
The problem is, that I receive a lot of double sigK keys.
There are e.g. two SOG keys in sigK diagnostic, one is valid, the other one produces faulty values, that disturb the SOG reading.
Both values seem to come from the USB adapter. When I have a look on the PGNs directly, there are no double values.
I got the hint, here in the forum, to filter the faulty keys in kplex. I tried to set up a filter in manual section of the kplex.conf, but it did not work.
Could someone please point me into the right direction and give me a example how the filter is used?
Martin