This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New OpenPlotter v1.0.0 available!!!!
#32
OpenPlotter works great with the OpenGl driver switched on. With latest kernel the GLXgears without the effect of
the display runs at around 1000 Frames per Second (FPS).

I only had a small problem with the startup. The startup sometimes halted at: checking display 800x480. Then the system lock-up and had to reboot..

Perhaps the startup is going too fast.

In the OpenPlotter config I have set the delay at 1 or 2instead of 0. And now with this delay the systems seems to starts without this problem.

Regards,

Bram
Reply


Messages In This Thread
New OpenPlotter v1.0.0 available!!!! - by Sailoog - 2018-05-28, 09:01 PM
RE: New OpenPlotter v1.0.0 available!!!! - by CVL - 2018-06-02, 09:59 AM
RE: New OpenPlotter v1.0.0 available!!!! - by verkerkbr - 2018-06-03, 05:56 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)