thanks that is confusing i will try again
i have it working
rpi3AP/client
wlan0
popup @taskbar = wlan0 associated my home net
wlan0 my ip address
uap0 associated openplotter
uap0 op's ip address
eth0 link down
wlan1 not associated
i scan networks i get 4 ap's, with the alfa adapter i get 20 ap's on a scan
it has happened a few times i have rebooted like a hundred times tring to use the usb for internet connection
OK i just setup as
rpi3:AP + client
share wlan0
in taskbar popup shows the rename3 not associated.wlan1 is the AP.
strange rebooted again it works correctly now..
that wlan change thru me off it was always wlan1
i have it working
rpi3AP/client
wlan0
popup @taskbar = wlan0 associated my home net
wlan0 my ip address
uap0 associated openplotter
uap0 op's ip address
eth0 link down
wlan1 not associated
i scan networks i get 4 ap's, with the alfa adapter i get 20 ap's on a scan
(2018-05-29, 06:21 PM)e-sailing Wrote: rpi3 AP/client -> does everything with internal wifi ! Don't use an usb wifi stick with this setting
rpi3 AP + client -> use wlan1 (internal wlan as AP) wlan0 should be the usb wifi
Without this rule sometimes internal wlan is wlan0 and othertimes the usb wifi stick is wlan0.
To solve this problem, internal wlan is set to wlan1 in udev.
But if there is a rename wlan in the list something went wrong.
Did that happen when you power up the rpi ?
Is it every time the same?
it has happened a few times i have rebooted like a hundred times tring to use the usb for internet connection
OK i just setup as
rpi3:AP + client
share wlan0
in taskbar popup shows the rename3 not associated.wlan1 is the AP.
strange rebooted again it works correctly now..
that wlan change thru me off it was always wlan1