NMEA into KPLEX from node-red?

[PaddyB]

How do I do that? Tried every combination of ports & ip address I can think of but nothing shows up in the diagnostic window. NMEA message is from another thread - $WIMWV,28,R,4.7,N,A*04

Node-red - 

Code:

[
   {
       "id": "eb4147d4.73a6d8",
       "type": "inject",
       "z": "3f30ea31.da3756",
       "name": "",
       "topic": "",
       "payload": "$WIMWV,28,R,4.7,N,A*04",
       "payloadType": "str",
       "repeat": "1",
       "crontab": "",
       "once": false,
       "onceDelay": 0.1,
       "x": 220,
       "y": 1380,
       "wires": [
           [
               "137d8646.f9660a"
           ]
       ]
   },
   {
       "id": "137d8646.f9660a",
       "type": "function",
       "z": "3f30ea31.da3756",
       "name": "",
       "func": "msg.payload =  msg.payload + \"\\n\";\nreturn msg;",
       "outputs": 1,
       "noerr": 0,
       "x": 480,
       "y": 1420,
       "wires": [
           [
               "5c27d805.90e408"
           ]
       ]
   },
   {
       "id": "5c27d805.90e408",
       "type": "udp out",
       "z": "3f30ea31.da3756",
       "name": "",
       "addr": "10.10.10.1",
       "iface": "",
       "port": "6666",
       "ipv": "udp4",
       "outport": "",
       "base64": false,
       "multicast": "false",
       "x": 680,
       "y": 1440,
       "wires": []
   }
]

KPLEX -

Code:

pi@openplotter:~ $ cat .kplex.conf
# For advanced manual configuration, please visit: http://www.stripydog.com/kplex/configuration.html
# Please do not modify defaults nor OpenPlotter GUI settings.
# Add manual settings at the end of the document.

###defaults

[udp]
name=system_a
direction=in
address=localhost
port=10110

[udp]
name=system_b
direction=in
port=10110

[tcp]
name=opencpn
direction=out
mode=server
ofilter=-**RMB
port=10109

[udp]
name=signalk
direction=out
ofilter=-OC***
address=127.0.0.1
port=55556

###end of defaults

###OpenPlotter GUI settings

[serial]
name=gps
direction=in
optional=yes
filename=/dev/ttyUSB0
baud=4800

[serial]
name=ais
direction=in
optional=yes
filename=/dev/ttyUSB1
baud=38400

[udp]
name=node
direction=in
optional=yes
address=10.10.10.1
port=6666

[udp]
name=tablet
direction=in
optional=yes
address=10.10.10.1
port=50000

###end of OpenPlotter GUI settings

###Manual settings