2018-09-06, 10:52 AM
(2018-09-05, 05:00 PM)John S Wrote:(2018-06-05, 01:10 PM)addboy Wrote:(2018-06-04, 08:50 PM)Sailoog Wrote: You have to set the option that match your hardware configuration, if not, you will get errors.
Check the manual and report your hardware configuration and details of error conditions: https://docs.sailoog.com/openplotter-v1-x-x/network
Thanks for the help! After a few tries I got it working!
Thx
Dave
Dave,
I'm putting Open Plotter on a new 3b+, I have reset the country to US successfully but WiFi still does not work. Can you describe what you did to get it working?
Still struggling with this issue here.
Thanks,
John
Hi, John-
I've experienced this before as well. What I've found is that the key is always in the settings in the OpenPlotter configuration application, specifically on the "network" tab. It obviously depends on your application, but the setting "client" is what I usually need/want, and once set, allows me to do exactly what I want - have the OpenPlotter Raspberry Pi join my existing network. Your mileage may vary.
Good luck!