2018-06-07, 06:16 AM
The position rudder must range from 0 to 1.1 volts. Maybe this is the problem? What is the voltage on adc pin 6? If the sensor reads above about 1 volt, or below 0.1 volt then no rudder position will ever be reported.
If you aren't measuring current at all, you could change the admux register and change the range for rudder feedback for 0 to 5 volts.
If you don't measure current, you absolutly must have end of track switches, or rudder feedback.
If you aren't measuring current at all, you could change the admux register and change the range for rudder feedback for 0 to 5 volts.
If you don't measure current, you absolutly must have end of track switches, or rudder feedback.