This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Actions error
#3
Whenever LAT and LON are set to send a message after 5 seconds of signal loss. I get the message "Problem with actions detected. Please check and save again"
I dont know how to switch on debug mode.

To simulate the above error, i just move the usb gps. Its just the puck type openplotter recomends.
After the warning message, i go to actions tab and the LAT action was gone.
I click apply without changing anything and the problem is gone.

I found debug mode. It just said to run openplotter via a terminal.
Same info box popped up. Same message.
Reply


Messages In This Thread
Actions error - by Tacmed - 2016-06-07, 11:52 AM
RE: Actions error - by Sailoog - 2016-06-07, 12:02 PM
RE: Actions error - by Tacmed - 2016-06-07, 03:19 PM
RE: Actions error - by Tacmed - 2016-06-09, 04:46 AM
RE: Actions error - by Sailoog - 2016-06-09, 09:18 AM
RE: Actions error - by Tacmed - 2016-06-10, 04:21 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)