(2018-07-25, 06:08 AM)It Paradyske Wrote:confirm this situation. 1.1.0 version has some errors such this one. Also NMEA generator doesn't works correctly, I can't to edit existing sentecies and add some sentencies, for example ROT, HDT e.t.c.(2018-07-24, 11:01 PM)kalle Wrote:(2018-07-24, 05:47 PM)Sailoog Wrote: Controller (arduino) is connected and was working before update. In version 1.0.0 everything is ok, but afterwards not working. If I choose "basic autopilot" even selection of pitch and roll are not possible and greyed out.
Same here, upgrade from 1.0.0 to 1.1.0.
IMU not functioning anymore. MPU-9250/9255 is still detected, but values for tillt heading pitch etc. are all "n/a".
Went back to 1.0.0, and it worked again.
Regards
Hans Fix
no imu data after update
|
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
no imu data after update - by kalle - 2018-07-24, 08:34 AM
RE: no imu data after update - by Sailoog - 2018-07-24, 05:47 PM
RE: no imu data after update - by kalle - 2018-07-24, 11:01 PM
RE: no imu data after update - by It Paradyske - 2018-07-25, 06:08 AM
RE: no imu data after update - by sapers - 2018-08-16, 03:22 PM
RE: no imu data after update - by Sailoog - 2018-07-25, 06:28 PM
RE: no imu data after update - by kalle - 2018-07-25, 10:52 PM
RE: no imu data after update - by Sailoog - 2018-07-26, 06:20 PM
RE: no imu data after update - by kalle - 2018-07-29, 10:34 AM
|
Users browsing this thread: 1 Guest(s)