2018-09-21, 04:30 PM
(This post was last modified: 2018-09-21, 04:36 PM by seandepagnier.)
try commenting line 1225 in client.py and any more lines in client.py that throw exceptions.
Not sure why this is triggered for you but it works for me.
I also use a different wiring from the link you posted. Check pypilot/lcd/ugfx/ugfx.cpp line 568. You can change these and recompile, but keep in mind I use the other io for button presses, so you would have to modify client.py as well to remap them. It would be easiest to just use DC on 25, and RST on 24. The rest of the connections are the same.
I think you only need to change DC to pin 25
Not sure why this is triggered for you but it works for me.
I also use a different wiring from the link you posted. Check pypilot/lcd/ugfx/ugfx.cpp line 568. You can change these and recompile, but keep in mind I use the other io for button presses, so you would have to modify client.py as well to remap them. It would be easiest to just use DC on 25, and RST on 24. The rest of the connections are the same.
I think you only need to change DC to pin 25