2018-09-01, 07:43 PM
Hello Iris,
you need to solder a header (J503) on your HAT so you can simple access the GPIO pins (marked in blue). These pins are directly routed to the Raspberry Pi. You could use these pins either as input or output.
See the chapter 5 in the user guide: https://www.rooco.eu/2018/08/31/user-guide/
Regards,
Thomas
you need to solder a header (J503) on your HAT so you can simple access the GPIO pins (marked in blue). These pins are directly routed to the Raspberry Pi. You could use these pins either as input or output.
See the chapter 5 in the user guide: https://www.rooco.eu/2018/08/31/user-guide/
Regards,
Thomas