2018-08-03, 10:15 AM
(This post was last modified: 2018-08-03, 10:34 AM by Johnnysails.)
(2018-08-02, 08:40 PM)seandepagnier Wrote:(2018-07-30, 10:54 PM)Johnnysails Wrote: I have failed dismally in trying to get my Adafruit LSM303DLHC + L3GD20 chipped IMU board working. See my post on "How do I". The i2c addresses are detected as 19 and 1e. The RTIMULib settings file however always defaults to IMU type13 and my IMU is never detected.
I would appreciate any advice on an IMU that is known to work properly on the latest version of openplotter pypilot 1.1.0. alpha.
Try deleting the RTIMUlib
I just fixed this in pypilot a few days ago. It can switch to any supported sensor without restarting the autopilot.
(2018-08-03, 10:15 AM)Johnnysails Wrote:Thanks for the reply.(2018-08-02, 08:40 PM)seandepagnier Wrote:(2018-07-30, 10:54 PM)Johnnysails Wrote: I have failed dismally in trying to get my Adafruit LSM303DLHC + L3GD20 chipped IMU board working. See my post on "How do I". The i2c addresses are detected as 19 and 1e. The RTIMULib settings file however always defaults to IMU type13 and my IMU is never detected.
I would appreciate any advice on an IMU that is known to work properly on the latest version of openplotter pypilot 1.1.0. alpha.
Try deleting the RTIMUlib
I just fixed this in pypilot a few days ago. It can switch to any supported sensor without restarting the autopilot.
Forgive my ignorance, how do I update pypilot to incorporate that fix, outside a general OpenPlotter update. I had previously deleted both RTIMULib.ini files from the pypilot folder without any success in recognising my IMU, maybe they are not the correct files to delete.