If nothing happens when you click on the TX PGN Enable button start openplotter from terminal ("lx terminal" or shortkey alt ctrl t) and enter openplotter.
There should be an error message when you click on the button.
In the past Signal K wasn't able to work at baud rate higher than 115200. It is now. Openplotter will support higher settings in v2.x.x. But you can set the baud rate manually in Signal K admin if you want.
The communication protocoll on the serial side takes more bytes than on the can bus side. If you don't want to lose any sentence on highest can bus (250000) load. You have to use a baud rate higher than 460800.
Under normal condition 115200 will do. 230400 is better. The latest canusb can work at 921600 that's best. They can also switch to slcan mode. Then they can work as linux can0 network (but that's not so secure as working with actisense protocol) (Slcan is also compatible with canboat/Signal K (typical used by canable)).
Understood. Thanks for clarification.
But for now 115200 baud is what's working and so far there is only those two PGN's I want to transmit. As soon as I set it to 230400 in the SK admin panel, those PGN's don't make it into the MFD.