2018-09-16, 04:07 PM
(2018-09-16, 10:56 AM)Sailoog Wrote: You have to set your device only in serial tab. Do not change opencpn or kplex defaults. when you define the serial input in serial tab OP will do this job for you. Are you connecting by GPIO pins or USB? If you are using GPIO be sure you do not provide more than 3.3V.
Thanks for the reply!
I am just using a rs232 to usb cable and a separate 12v 2a power supply
under serial I give it a name and under assignment I changed it to nmea 0183 out with a baud rate of 38400, does that sound right?
Thanks very much