This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
General help wanted on multiplexing
#13
John,

My plan is to use TCP to get iPad autopilot data to openCPN and then output via serial from openCPN into my ST6000. iI have set it up at home and get data into OpenCPN but have yet to check it out on my boat. However I am down there next week and will post further on my results.

I use two ports in iSailor, one to get legacy NMEA from openplotter and one to output autopilot data to openCPN.

I am documenting my approach and will post when its checked out.

Chris
Reply


Messages In This Thread
General help wanted on multiplexing - by Newt2u - 2018-09-16, 12:07 PM
RE: General help wanted on multiplexing - by Newt2u - 2018-10-26, 07:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)