This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Temperature Value not shown in OpenCpn
#1
Dear all,

I have a Waveshare 10DOF IMU BMP280 connected to my Raspberry Pi 2 running the latest OpenPlotter. 
It shows pitch, roll, temperature but no pressure in Opencpn on my Laptop. The pressure is shown though in the "diagnostic signalk" window, as well as in OpenCpn running directly on the raspberry(!). See screenshot attached. 

It is not shown, when I access the NMEA data from OpenCpn running on my laptop. In the NMEA debug-window, it shows that its getting NMEA Data for the pressure, see picture attached. It just doesnt display the pressure in the OpenCpn dashboard. See other screenshot. 

What could be the problem? 

Regards
Max 
Reply


Messages In This Thread
Temperature Value not shown in OpenCpn - by zugol - 2018-09-19, 11:55 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)