2019-11-10, 07:37 PM
I've ugraded OP2 with Rasbian Buster, pypilot from https://github.com/pypilot/openplotter-pypilot but always same problem. IMU is ok but no sign of pypilot (connect failed to localhost:21311)
IMU seem assigned on ttyS0. In signal K, I can see AMAO, where was assigned pypilot before.
I fear a material problem, but not sure. The Arduino on the pypilot card is not powered by the RPi in 3.3V, just by 12V when plugded, and just a red led is lighted on the Arduino Nano, not the Rx - Tx one's.
Could it be a problem with CPC5001 ? Is it possible to connect directly 1 and 2 of Arduino with Rx Tx of J4 (https://pypilot.org/schematics/hbridge_controller.pdf) or is no use to test ?
Thank's
IMU seem assigned on ttyS0. In signal K, I can see AMAO, where was assigned pypilot before.
I fear a material problem, but not sure. The Arduino on the pypilot card is not powered by the RPi in 3.3V, just by 12V when plugded, and just a red led is lighted on the Arduino Nano, not the Rx - Tx one's.
Could it be a problem with CPC5001 ? Is it possible to connect directly 1 and 2 of Arduino with Rx Tx of J4 (https://pypilot.org/schematics/hbridge_controller.pdf) or is no use to test ?
Thank's