2019-11-10, 10:16 PM
(2019-11-10, 07:37 PM)DjelaliTricks Wrote: I've ugraded OP2 with Rasbian Buster, pypilot from https://github.com/pypilot/openplotter-pypilot but always same problem. IMU is ok but no sign of pypilot (connect failed to localhost:21311)AMA0 when? You might need to edit /boot/config.txt
IMU seem assigned on ttyS0. In signal K, I can see AMAO, where was assigned pypilot before.
Quote:I fear a material problem, but not sure. The Arduino on the pypilot card is not powered by the RPi in 3.3V, just by 12V when plugded, and just a red led is lighted on the Arduino Nano, not the Rx - Tx one's.
Could it be a problem with CPC5001 ? Is it possible to connect directly 1 and 2 of Arduino with Rx Tx of J4 (https://pypilot.org/schematics/hbridge_controller.pdf) or is no use to test ?
Thank's
Probably no problem with the cpc5001. Can you boot older openplotter, or try the tinypilot image to test? This will tell you if the problem is hardware or not.
The openplotter-pypilot script is updated very new, and there is not serial port management in op 2 yet so it is not much surprise you found issues.