This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PyPilot doesn't work after upgrade
#37
(2019-11-14, 03:41 AM)seandepagnier Wrote: are you on tinycore then?  I think the troubleshooting doesn't assume this.   You might need to issues:

The other way is just put a fresh tinypilot image on sd card.   It will work if the connections are right and the motor controller is ok.

I use tinypilot_28062019.img.xz, I've just installed on a new SD card


Quote:$ sudo sv d pypilot

ensure pypilot isn't running:
$ ps aux | grep python
$ ps aux | grep pypilot

You could try running pypilot or pypilot_servo at this point.

It give me the same results...

I've an 1 year old card (ordered in december 2018).

Does upgrading Arduino Nano can resolve problem ?

I've also connected the arduino directly to Pi GPIO (3,3V, grnd, RX Nano -> Tx RPi, Tx Nano-> Rx Nano)... Arduino seem to react (Rx-Tx leb blinding), but no responce from pypilot
Reply


Messages In This Thread
RE: PyPilot doesn't work after upgrade - by kalle - 2019-01-11, 01:18 PM
RE: PyPilot doesn't work after upgrade - by kalle - 2019-01-11, 02:16 PM
RE: PyPilot doesn't work after upgrade - by kalle - 2019-01-12, 02:10 PM
RE: PyPilot doesn't work after upgrade - by DjelaliTricks - 2019-11-14, 12:38 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)