This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PyPilot doesn't work after upgrade
#15
Thanks at @ Jim and Sean.

The IMU gives data now. And everything is back working in my test layout. When  I´m back to the boat
I will start connecting the drive (Neco 17DR8 24V) and do seatrails.

The new improvements to the autopilot tab and the servo calibration looks great.

I,m also working to see how I get my actual Rudderfeedback-Sensor (Roberstson/Simrad) RF300 wich seems
to work by sending a feequencie  up tk 7.200Hz into the 0-1.1V required by the arduino analog pin4.

Save sailing
Andreas
Reply


Messages In This Thread
RE: PyPilot doesn't work after upgrade - by xfactor99 - 2019-01-09, 10:08 AM
RE: PyPilot doesn't work after upgrade - by kalle - 2019-01-11, 01:18 PM
RE: PyPilot doesn't work after upgrade - by kalle - 2019-01-11, 02:16 PM
RE: PyPilot doesn't work after upgrade - by kalle - 2019-01-12, 02:10 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)