TCP In from iPad

[johnwilde]

Thanks chaps.

Thanks to your pointers, it got me looking in the right directions and I've solved the issue. I now have the XTE sentances coming back over Wifi/UDP from iSailor to kplex.

For anyone else who stumbles on the thread, the issue was IP Addresses. I was trying to put an IP address in the kplex settings, when this needed to be left blank.

I did the following:

* Set up a UDP Out network on kplex, specifying the IP address of the iPad iSailor is on and unique port (I used 10101);
* Set up a second UDP In network kplex, leaving the IP blank and using a different port (I used 10102);
* On iSailor, set up one new UDP connection, specifying the opposing ports from above. So whatever was OUT on kplex, should be you IN on iSailor, and vice versa;
* Make sure autopilot is configured as a datatype within that connection on iSailor.

With these settings, I get all the NMEA data from me OP sent over wifi to the iPad and then when a track or dodge is set for AP on iSailor, XTE commands are returned.

Thanks again for your help. Hope this helps out someone else if they come across it.



John