2018-11-05, 05:28 PM
Hi john,
Did some playing around today following your setup. When setting up the UDP in from iSailor, I noticed the system UDP input in kplex on port 10110, which is standard for onboard NMEA data, I think. So I just set an output in iSailor on this port for autopilot. It works just fine... can’t test the TCP output on the same port to get NMEA into ipad but don’t see why it should not work, it did before.
Chris
Did some playing around today following your setup. When setting up the UDP in from iSailor, I noticed the system UDP input in kplex on port 10110, which is standard for onboard NMEA data, I think. So I just set an output in iSailor on this port for autopilot. It works just fine... can’t test the TCP output on the same port to get NMEA into ipad but don’t see why it should not work, it did before.
Chris