This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Best way to send message to esp32 to change pin state
#7
I have used the wifi approach (Internet of Things on Board). All the ESP8266 and ESP32 connect to the OpenPlotter RPi using wifi and SignalK. This works very nice and so far no problems have been detected. The project is documented on my project pages: https://sites.google.com/site/olewsaa/in...s-on-board and the detail pages for each IoToB device. All the code are published on gitlab, https://github.com/olewsaa/Yacht-computer .

Ole
Reply


Messages In This Thread
RE: Best way to send message to esp32 to change pin state - by olewsaa - 2018-12-21, 08:24 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)