This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor controler hook up
#1
I need to know how the 4 serial wires are coded coming out of the motor control. I have White, Brown, Black, Blue..


Thanks
Reply
#2
Hello I need to Know what the pinouts for the 4 wires are :ie tx rx grd 5+v

black  ==
white  ==
blue    ==
Brown ==
Reply
#3
(2019-01-05, 08:11 PM)ddelorme Wrote: Hello I need to Know what the pinouts for the 4 wires are :ie tx rx grd 5+v

black  ==
white  ==
blue    ==
Brown ==

Brown - 3.3v (pin 1)
White - TX (pin 8)
Blue - RX (pin 10)
Black - GND (pin 6 or 9)

Rgds

Keith White
Reply
#4
thanks
Reply
#5
What are the 6 pins on the Moitessier hat? can they be used to connect the motor controller?
Reply
#6
Yes, 4 of them are used, the 3v3, gnd, tx and rx pins.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)