2019-01-23, 09:54 PM
(2019-01-23, 04:26 PM)Didier B Wrote:(2019-01-23, 03:24 PM)ddelorme Wrote: looks good is there room for another hat in the case?It is working with a Pi3B + ; also tested wih a a PI 3 B and should work with a Pi 2
Will it work with A pi3+
What is the power draw like from the ssd?
I have a similar Buck converter same chip no heat sink.
Dont worry Swear like a sailor. It is good for your mental health I did a bit the other day after trying to debug a few unrelated issues in code over several days. Only to find out it was a few loose connections. Du!
Some converters are sold with a heat sink, some are not ... I have a loonnng heat sink from which I cut slices as requested ...
I don't think there is room enough for another hat. What kind of hat would you like to pack with ?
Connectors ! They should always be the most expensive part of any project
I have a older saillog breakout board that i have my mpu mounted to and some lines for buttons and 1w breakout and soon a breakout for serial tx and gnd so i can route NMEA to my radio.
I have been looking to design a case but i suck at freecad...
I had good connectors just I must of been 3 sheets to the wind when i crimped them and did the pull test. Santa Maria!
I just got my updated boards back from OSH park... soo pleased They are identical to the first version that was wrong DUH! I used the same filename DUH!. Something got messed up as i checked my local file and it is the new version and the old one was over written when I made the changes...
Used a few choice pirate words.. Hornswaggled by a [b]Son of a biscuit eater ... Dirty [b]Freebooter...[/b][/b]
Then I sent a nice polite email.
Hopefully they cut me a deal on faster shipping. I have 3 projects very near completion Wireless wind sensor/ anchor light, New code for my Epsolar charge controllers and a update to my Auto pilot.