This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CANBus <---> OPlotter <---> N2K
#1
Hi,

Need some advice on if I can connect a device that is CANBus enabled and use a CANBus and a N2K adapters on Openplotter to act as a gateway between the two?

There's an inverter / charger connected to an N2K network, but it doesn't support CANBus, only CANOpen / NMEA2000 and a battery management system that only supports CANBus. Is there a way to pass messages in both directions between CANBus and N2K and monitor them in Openplotter.

There is a Moitessier HAT installed on OpenPlotter, so PiCAN isn't an option without purchasing another Pi to instal it on.

Just want to make sure that Openplotter can pass messages in both directions between the bus types before I buy the adapters.

Thanks

Craig
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)