(2020-06-09, 05:04 PM)glowntiger Wrote: Hi,
ST1 is availible in the app since 2.1.8 (published today)
be sure pigpio is installed:
Code:sudo install pigpio
Connect the yellow st1 wire to one of the Inputs: (In1-In4)
In the widget you can chose wich Input you use. On the Data-Output tab you can chosse the UDP Port.
The best way I think is to use SignalK. Make a udp Connection with the Port you choose and set NMEA0183 Data. Then you get all Data in Signal K. An $STALK parser is in the NMEA0183 SignalK app intigratet.
The reason why you only recieve data from the bus is the electric site and owed it that pigpio can only read bitbanging seatalk1!
Hi Thomas, I updated MCS 2.1.8 and added St1, but there is something wrong. SignalK no longer receives the 1W service. I tried to reinstall both the update and the three probes but as you can see from the photo, in MCS they are installed and SignalK does not receive ... Do I have to install "pigpio"? I'm stuck, see photos (I don't want to mix messes with the terminal ..) (OP2 on Rp4 with Moitessier and MCS, no instrument connected, apart from the three probes). If you want to take a look with AnyDesk let me know.
[img][/img]
[img][/img]
[img][/img]
[img][/img]