2021-05-30, 06:12 AM
hi gniersma,
how do you get the nmea0183out data to the sentence event?
If the TX LED did not flash, signalk did not send anything to this port.
According to my experience it is easyer to use the serial ports in signalk without the serial app....
I have take a look in the cb200 manual. The device did have rs232/485. How do you have connected it?
The RX led must flash according to the incomming data.
The manual for the connection (also in english) you find here:
https://www.gedad.de/support/
how do you get the nmea0183out data to the sentence event?
If the TX LED did not flash, signalk did not send anything to this port.
According to my experience it is easyer to use the serial ports in signalk without the serial app....
I have take a look in the cb200 manual. The device did have rs232/485. How do you have connected it?
The RX led must flash according to the incomming data.
The manual for the connection (also in english) you find here:
https://www.gedad.de/support/