This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cytron 13a motor controller
#1
Hi all,
I would like some help please if there is anyone who can guide me on how to connect the tinypilot computer i purchased from sean to my cytron 13a motor controller from robotshop.com.
The controller has gnd, 1x pwm and 1x dir connections.
I have tried unsuccesfully to upload pypilot motor.ino to arduino but cannot get it to compile after many attempts.i have very little arduino coding knowledge and was hoping there is another way to get the controller talking to the tinypilot.
Any advice greatly appreciated.
Thanks
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)