This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Different PGNs for speed in OP and Raymarine
#1
Hi,

i set up OP Plotter on my raspi with the can-bus adapter sold by the sailoog team. Everything works fine so far (even the AIS over N2K is working now)

One problem is still not solved: I use a raymarine i50 speed display in my cockpit. i can switch between speed and SOG. the SOG is always "---" or 0.

looking in the kplex data stream and outgoing PGNs there is an PGN for SOG which is send to the network, but (from my mind, im not at the boat this month) these are different PGNs. The ones send do not match the ones accepted from raymarine. is there a possibility to match the PGNs? Or what else am I doing wrong?

best regards

Thomas
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)