This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
high cpu ussage in opencpn when aouto pilot is using route
#6
(2019-08-10, 12:47 AM)rastam4n Wrote:
(2019-08-09, 10:33 PM)ddelorme Wrote: solved i think It was due to opengl not being set in old rpi-config there is an option advanced opengl i set to on then opencpn cpu usage normalized at 20 to 30 %cpu.. I still have to  restart kplex in openplotter after reboot

So when you reboot you have to log in remotely to openplotter, run open plotter, and restart kplex in order for pypilot to see the motor controller? Or is there some other reason you need to restart kplex?
I have to restart kplex as the imu data is not getting sent to SignalK or openCPN. but once i restart kplex it all works.. in the new opencpn pypilot app it says it does not see the motor controller but it works.
Reply


Messages In This Thread
RE: high cpu ussage in opencpn when aouto pilot is using route - by ddelorme - 2019-08-12, 06:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)