This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RE: RPI3B+ no hdmi after update [Solved]

I wanted to use a RPI3B+ in my shipsytem, currently running on RPI3, so I did a new install on USB using noobs in the RPI3B+.
After installation everything Ok, updated using openplotter update button, after update no hdmi connection.
During start-upI see the splash screen, followed by the Noobs recovery page, then start-up auto continues, but screen blanks.
OP can be connected through VNC, sits in low resolutipn and will not change resolution.
Any Ideas?
You can try to change the resolution with sudo raspi-config.
(08-09-2019, 05:44 PM)e-sailing Wrote: You can try to change the resolution with sudo raspi-config.

That worked, thanks, problem solved!

Forum Jump:

Users browsing this thread: 1 Guest(s)