(2019-12-17, 06:20 PM)Latitude Wrote: Please provide instructions on how to get Daisy Hat working with Raspberry Pi 4 and OpenPlotter v2.0. What are the serial configurations needed to use the hat plugged into the R Pi 4 GPIO?
Try this:
- Install and open "Serial" app.
- Click on UART button, accept and reset.
- Open again Serial app and you should see a new device in the list: ttyS0
- Select this device and provide an alias "daisy" and select NMEA 0183.
- click Apply
- Then go to "Connections" tab, select the device and click on "Add to signal K"
- Select 38400 bauds and click "Auto".
- Signal K will restart and you are done. You should get data in SK.
From Daisy page:
Note: On the Raspberry Pi 3 and 4, UART0 is occupied by the built-in Bluetooth radio. Bluetooth may not be available when using the dAISy HAT.