2020-10-30, 03:50 PM
It's good you kept the 5v power supply for the pi away from the inertial sensors. I think it may have a bigger affect than the controller.
As for rotating the screen 90 degrees.... Hmm it's 48x84 so the layout of what is displayed would have to be completely different and this needs more software. There is an option to rotate 180 degrees...
The easiest way to rotate 90 would be to rotate the pi inside if possible, or it's possible to make a board which rotates it by 90 in hardware relative to the pi, I used to have a few of these but stopped making them because it was not the right orientation for most cases.
Do the buttons work?
As for rotating the screen 90 degrees.... Hmm it's 48x84 so the layout of what is displayed would have to be completely different and this needs more software. There is an option to rotate 180 degrees...
The easiest way to rotate 90 would be to rotate the pi inside if possible, or it's possible to make a board which rotates it by 90 in hardware relative to the pi, I used to have a few of these but stopped making them because it was not the right orientation for most cases.
Do the buttons work?