This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
OMG under voltage

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
OMG under voltage
baltika_no_9 Offline
Senior Member
****
Posts: 323
Threads: 10
Joined: Sep 2016
Reputation: 21
#2
2019-09-23, 03:25 PM (This post was last modified: 2019-09-23, 03:33 PM by baltika_no_9.)
Well the cable powering the Pi is a candidate perhaps. Is it powered via the micro USB or direct to the GPIO pins?

I assume you are powering the Pi from the power supply directly? (rather than via the USB hub)

If you don't connect the powered hub presumably the UV message doesn't occur?
Find
Reply


Messages In This Thread
OMG under voltage - by rastam4n - 2019-09-23, 02:57 PM
RE: OMG under voltage - by baltika_no_9 - 2019-09-23, 03:25 PM
RE: OMG under voltage - by rastam4n - 2019-09-23, 04:26 PM
RE: OMG under voltage - by baltika_no_9 - 2019-09-23, 04:40 PM
RE: OMG under voltage - by Sailoog - 2019-09-23, 04:45 PM
RE: OMG under voltage - by Sailoog - 2019-09-23, 04:12 PM
RE: OMG under voltage - by pinguino - 2019-09-24, 10:53 AM
RE: OMG under voltage - by rastam4n - 2019-09-24, 03:46 PM
RE: OMG under voltage - by pinguino - 2019-09-24, 09:37 PM
RE: OMG under voltage - by b135802 - 2019-10-27, 06:49 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)