2019-10-13, 05:58 PM
Hi to all !
Openplotter ver 1.2.0 on RPi 3B+, wind sensor like this : https://www.argentdata.com/files/80422_datasheet.pdf
I connected the anemometer to the RPI via gpio5 and I can see the switc 1/0 on SignalK panel. I would like to be able to convert the values 1/0 to a speed value that can be displayed on the signalK panel. I would also like to be able to do this with the analog sensor, after appropriate conversion of the signal via ADC MCP3008 to digital signals.
Is this possible?
I am not a programmer and I am getting lost among the various Openplotter manuals, opencpn, SignalK, node red, Kplex, etc..
Could you give me a starting point and which manuals to focus on in order to find a solution?
Even the ready-made solution would be welcome
Thanks in advance
Paolo
Openplotter ver 1.2.0 on RPi 3B+, wind sensor like this : https://www.argentdata.com/files/80422_datasheet.pdf
I connected the anemometer to the RPI via gpio5 and I can see the switc 1/0 on SignalK panel. I would like to be able to convert the values 1/0 to a speed value that can be displayed on the signalK panel. I would also like to be able to do this with the analog sensor, after appropriate conversion of the signal via ADC MCP3008 to digital signals.
Is this possible?
I am not a programmer and I am getting lost among the various Openplotter manuals, opencpn, SignalK, node red, Kplex, etc..
Could you give me a starting point and which manuals to focus on in order to find a solution?
Even the ready-made solution would be welcome
Thanks in advance
Paolo