This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine  ›  Pypilot  ›  General discussion  ›  [Solved] Sketch error 'crc8' was not declared in this scope

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Solved] Sketch error 'crc8' was not declared in this scope
Onno
Junior Member
**
Joined: Oct 2019
Posts: 2

Reputation: 0
#1
11-03-2019, 06:30 AM (This post was last modified: 11-13-2019, 03:34 PM by jim321.)
When I verify the motor.ino I get this error? 'crc8' was not declared in this scope
  Reply
jim321
Moderator
*****
Joined: Jun 2017
Posts: 686

Reputation: 19
#2
11-03-2019, 08:31 AM
if you are using arduino ide to load the program, you need to add a new tab and paste the crc in it.
https://github.com/pypilot/pypilot/blob/...otor/crc.h
mare liberum
  Reply
Onno
Junior Member
**
Joined: Oct 2019
Posts: 2

Reputation: 0
#3
11-11-2019, 08:25 AM
That did the job thanks!
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)