This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Upgrading tinyPilot for RPI-illiterate
#1
I've downloaded the 2020_10_27 image to my mac; I ran the RPI imager utility to write it to an SD card (but NOT the SD card that came with the tinypilot -- I'm holding that one safely until I get something new installed). 

I'm going to place this new SD card into the TinyPilot computer...but presumably I have to do something to move the new "image" file somewhere and make it the "thing to run when the TP is powered up". 

Does anyone have any suggestions for how to get from "I've got an SDCard with an image on it" to "my TP now runs that image when I start it up, rather than version 0.12" ?

--John

Never mind...

I just did the most obvious thing (plugged in the newly-written SD card, applied power) and it showed up saying version 0.24 ... so I guess I'm good to go.

--John
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)