2019-11-27, 11:03 AM
I have a problem with getting AIS sentences into OpenCPN
I have an E-Track 350 Calls B+ AIS transponder connected to my NMEA2000 network. This is working well and and I see AIS targets on my Simrad chartplotter.
I have the CAN-USB unit connected to my Pi running Openplotter 2. It is receiving NMEA2000 data from the CAN-USB unit and via Signalk that data is available in OpenCPN.
The issue is though there doesn't seem to be any AIS sentences at all when check in the OpenCPN diagnostics tab, and so no AIS targets are displayed.
Unlike in Openplotter 1 there doesn't seem to be any NMEA2000 diagnostics in this version so we can't see what sentences Signalk is receiving from the NMEA2000 network, but since AIS is working fine over the network on my chartplotter I must assume they are there, and for some reason Signalk just isn't doing anything with them.
I have an E-Track 350 Calls B+ AIS transponder connected to my NMEA2000 network. This is working well and and I see AIS targets on my Simrad chartplotter.
I have the CAN-USB unit connected to my Pi running Openplotter 2. It is receiving NMEA2000 data from the CAN-USB unit and via Signalk that data is available in OpenCPN.
The issue is though there doesn't seem to be any AIS sentences at all when check in the OpenCPN diagnostics tab, and so no AIS targets are displayed.
Unlike in Openplotter 1 there doesn't seem to be any NMEA2000 diagnostics in this version so we can't see what sentences Signalk is receiving from the NMEA2000 network, but since AIS is working fine over the network on my chartplotter I must assume they are there, and for some reason Signalk just isn't doing anything with them.