2019-12-07, 04:49 PM
Re-installed Raspian Buster and then Openplotter settings 2.0.17. From that I installed Signalk 2.0.6
The installtion didn't so any errors, and claimed the signlk server is running on port 3000.
This isn't the case though. A simple 'sudo netstat -tlnp | grep 3000" does not show anything.
I tried re-installing signalk but still the server doesn't load at boot.
I then manually ran an installation of it, but again it would not run at boot. The server runs fine if I manually load it by typing 'signalk-server' but i really need it running from boot.
I don't know if this is a problem with OP 2.0.17 and/or Signalk 2.0.6 or even the current version of Buster, as my other sim card had slightly older versions of all the software.
The installtion didn't so any errors, and claimed the signlk server is running on port 3000.
This isn't the case though. A simple 'sudo netstat -tlnp | grep 3000" does not show anything.
I tried re-installing signalk but still the server doesn't load at boot.
I then manually ran an installation of it, but again it would not run at boot. The server runs fine if I manually load it by typing 'signalk-server' but i really need it running from boot.
I don't know if this is a problem with OP 2.0.17 and/or Signalk 2.0.6 or even the current version of Buster, as my other sim card had slightly older versions of all the software.