This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OP2 UDP connection output of AIS data
#1
In OP1, I added a connection into the main connection table and set the IP address:port number and used a filter to control which nmea/signalk messages were passed to that connection. I've been looking around the apps, but cannot seem to find the right place to add a UDP connection to send AIS data to AISHub.

Could someone point me in the right direction of where I add these in OP2?
Reply
#2
You have a signal k plugin to send data to AISHub
Reply
#3
(2020-01-26, 01:20 PM)Sailoog Wrote: You have a signal k plugin to send data to AISHub

Cool, I thought the aisreporter plugin was just for marinetraffic and not others. I misread its description.
Reply
#4
I installed rtl_sdr using these instructions: https://www.fontenay-ronan.fr/ais-receiv...h-rtl-sdr/

It has been working really well for me with OP2. I have it outputting on port 10112 using this command in a terminal window:

rtl_ais -n -P 10112

You should be able to get it to start with the RPI start using a command in rc.local.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)