Hello Ranur, just found your Thread. Are you shure the ADS1115 is set to ADDR 0x48 ?
It should be recognized in the Serial Debug Stream just after first booting. If not, it has an ADDR Line, set this to GND.
Look here for the Addresses: https://www.ti.com/lit/an/sbaa408/sbaa408.pdf
This PIN has also funny Addressmodes where you can set it to use one of 4 Adresses with only 1 BIT !
But the SigKSens software wants it to be on 0x48.
Good Luckj
Holger
It should be recognized in the Serial Debug Stream just after first booting. If not, it has an ADDR Line, set this to GND.
Look here for the Addresses: https://www.ti.com/lit/an/sbaa408/sbaa408.pdf
This PIN has also funny Addressmodes where you can set it to use one of 4 Adresses with only 1 BIT !
But the SigKSens software wants it to be on 0x48.
Good Luckj
Holger