2023-07-22, 04:42 PM
I’m looking into this again, today. I have a breakout board for the VGA port and the sensor ready. I need to hook up the four wires but I can already scan the i2c ports using i2cdetect.
In the openplotter setup it says i2c sensors can only be installed on Pi. However, technically there should be no difference in HOW to access existing ports on Pi or Ubuntu Laptop.
Can someone point me to the i2c sensor daemon / server repo? I would like to check if I can just compile and start this given proper udev rules (that I still need to understand).
If nothing works, I’ll try to use tinypilot and an old Raspberry Pi 1
In the openplotter setup it says i2c sensors can only be installed on Pi. However, technically there should be no difference in HOW to access existing ports on Pi or Ubuntu Laptop.
Can someone point me to the i2c sensor daemon / server repo? I would like to check if I can just compile and start this given proper udev rules (that I still need to understand).
If nothing works, I’ll try to use tinypilot and an old Raspberry Pi 1