2020-03-07, 06:08 PM
Well I have it sending data to signalK need to clean up the bounce a bit. A scope to see the signal i am getting would be nice.
Any recommendations on a nice small Power converter for an esp32. 12 -16 v -> 7 to 9 volts. I am using a esp32 devkit V1.
My esp goes into ap mode if it does not have or cant find openplotters' credentials. from my phone or laptop i can then set the connection info.
I still have to test if i can do OTA updates.
I cant seem to get SignalK to generate a VHW sentence for Opencpn...
Any recommendations on a nice small Power converter for an esp32. 12 -16 v -> 7 to 9 volts. I am using a esp32 devkit V1.
My esp goes into ap mode if it does not have or cant find openplotters' credentials. from my phone or laptop i can then set the connection info.
I still have to test if i can do OTA updates.
I cant seem to get SignalK to generate a VHW sentence for Opencpn...