2020-05-21, 05:56 PM
(2020-05-18, 03:25 PM)Johnnysails Wrote: Thank you Sailoog and I really appreciate all you and the team have achieved with 2.0.
All the SDR-VHF apps, except tv, are working well on my cheap and a few years old SDR with a home made whip aerial located 2m off the ground in my garden. I have tried the calibration pop-up lots of times without success however kal in terminal works every time. Out of interest, as I’m not a software engineer, where does the information go to in the programme, after clicking on the pop-up buttons which then opens the terminal and saves the initial ppm?
If you are running the latest version of openplotter-sdr-vhf app the GUI runs exactly the same than running kal in a terminal including gain.