How have you implemented temp/preasure/humidity?

[SkipperEarly]

Have put the two environmental sensores (humidity/temp, pressure/temp ) in a seperate housing and wired up as describted in the manual. Have upgraded to OP 0.8beta as advised and restarted OP but in the ICU tab the sensors are not detected.

I wonder if I damaged the sensors when soldering them onto the board. Can measure 3.2V on the pins.

Any advise on how to proceed now?

Thanks

---

I meant of course I2C sensor tab above.

I also observed, that when I start within OP the actual OP section after the logo it takes nearly half a minute until the program actually starts and opens the tab.