2021-03-11, 08:12 PM
Initial situation : I have an USB GPS receiver connected to openCPC via this openCPN connection :
Network, Input, Signal K, localhost, 3000, 1. And it works OK !
I need to send the position to the VHF NMEA RS232 input. What I did :
Network, Input, Signal K, localhost, 3000, 1. And it works OK !
I need to send the position to the VHF NMEA RS232 input. What I did :
- I plugged an RS232 USB COM port in my USB2.0 HUB ;
- in SERIAL, I gave an alias (vhfrs232) to the detected USB port and established a 4800 Baud connection to Signal K ;
- In Signal K, I can see the connection, without any activity (no 'pumping')
- In openCPN i created a connection :
Network, UDP, 0.0.0.0, 10118, opencpnOUT, Transmit GLL.
- In SK, I created a connection opencpnOUT
UDP, 10118, nmea1data (?), Ignored GLL.
- finally I edited the device connection :
vhfrs232, Serial, , 4800, Output Events nmea0183out (?), Ignored GLL
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you