Posts: 45
Threads: 12
Joined: Jan 2017
Reputation:
1
Just installed open plotter and tried connecting to it with vnc and the desktop display is so low that I can't do anything. opening the network config window to set Ip information is too large for the desktop. How do I fix I can't find any settings for display resolution? such an easy bug to fix I think
Posts: 21
Threads: 5
Joined: Nov 2016
Reputation:
0
How I solved it was to install tightvncserver.
sudo apt-get install tightvncserver
and then run it:
tightvncserver
Then you connect to your.ip.adress:5901
If you google you also find out how to start this on boot.
Posts: 341
Threads: 0
Joined: Apr 2016
Reputation:
23
You can use rdp to connect to openplotter. It use its own resolution. Or you use rpi configuration file /boot/config.txt and delete on some lines the #
(some lines of config.txt)
# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1